microcontroller - Should I connect the computer VBUS line to the 5V line of the board? - Electrical Engineering Stack Exchange
USB Made Simple - Part 2
USB-C for Engineers, Part 2 — Reclaimer Labs
A short primer on USB Type-C PD 3.0 specification and design - EDN
USB 101: An Introduction to Universal Serial Bus 2.0
Designing more flexible power banks with USB Type-C PD - Embedded Computing Design
USB Droop
USB Back Voltage
USB Drop
USB-C - Wikipedia
The basics of USB battery charging: a survival guide - Electronic Products
USB On-the-Go (OTG): Uses and Support | Maxim Integrated
USB 3.0 - Wikipedia
USB Type-C and power delivery 101 – Ports and connections - Embedded.com
The Basics of USB Battery Charging | Maxim Integrated
CP2102N requires a voltage divider on VBUS - Silicon Labs
USB Droop
USB in a NutShell - Chapter 2 - Hardware
USB Drop
What does it mean when a USB-C™ cable is rated at 3A? | by Benson Leung | Medium
Soft Mixed Signal Corporation USB 2.0 PHY IP Cores
USBREG — USB regulator control
USB Type-C™ + USB 3.2
Protecting USB From Power Surges | DigiKey
TUSB320: Maximum recommended VDD is 5V, where the USB voltage may be up to 5.25V. Can the VBUS supply the chip ? - Interface forum - Interface - TI E2E support forums
USB Power Delivery and Type-C
